Convert AutoCAD to ANSYS of dome shape element.Common catia or unigraphics interview question.Axisymmetric problem of thick-walled cylinders.Automatic CFD meshing on complex passenger cabin geometry.Application of Joints and Springs in ANSYS.ANSYS-VAMUCH User Interface Tutorial-Analysis 2-D Unit Cell.Ansys Workbench Transient MUlti Body Dynamics-part 2.ANSYS Workbench Mechanical 12.1 -A Kinematics and Dynamics Study.Ansys Tutorial : Electromagnetics Analysis II.Ansys Torque Application on a Composite Drive Shaft LS DYNA.ANSYS Parametric Design Language (APDL).ANSYS Finite Element Analysis University of Alberta Mechanical Engineering.Ansys Composite Analysis Shell 99 tutorial.ANSYS 12.1 (Part 3 of 3) ICEM CFD Hexa 2D Airfoil meshing.ANSYS 12.1 (Part 2 of 3) ICEM CFD Hexa 2D Airfoil meshing.ANSYS 12.1 (part 2 of 2) ICEM CFD Tetra/Prism meshing of a simple manifol.ANSYS 12.1 (Part 1 of 3) ICEM CFD Hexa 2D Airfoil meshing.ANSYS 12.1 (part 1 of 2) ICEM CFD setup for Tetra/Prism meshing of a simple manifold.Ansys tutorials by Teaching Staff me.cmu.edu.Advanced X-Sectional Results: Using Paths to Post Process Results.58-Advanced Removed Multi Section Solid.57-Multiple Removed Multi Section Solid.Extrude the area (length of extrusion = 20mm).Create the rib area through keypoints 200, 203, 204 Preprocessor > (-Modeling-) Create > (-Areas-) Arbitrary > Through KPs.Create the keypoints corresponding to the vertices of the rib.Utility Menu > WorkPlane > Change Active CS to > Working Plane
Change active coordinate systemWe now need to update the coordiante system to follow the working plane changes (ie make the new Work Plane origin the active coordinate).(Alternatively, type KWPLAN,1,200,201,202 into the command line) First change the active coordinate system back to the global coordinate system (this will make it easier to align to the new coordinate system) Utility Menu > WorkPlane > Align WP with > Global Cartesian(Alternatively, type WPCSYS,-1,0 into the command line).VADD,1,2You should now have the following geometry Add the two volumes together Preprocessor > (-Modeling-) Operate > (-Booleans-) Add > Volumes.Extrude the area (length of extrusion = 26mm) Preprocessor > (-Modeling-) Operate > Extrude > (-Areas-) Along Normal.Create a circle to obtain the curved top (XCENTER=51, YCENTER=180, RADIUS=51).Create the base rectangle (XCORNER=0, YCORNER=0, WIDTH=102, HEIGHT=180).(Alternatively, type KWPLAN,1,100,101,102 into the command line) Align the working plane to the 3 keypointsRecall when defining the working plane the first keypoint defines the origin, the second keypoint defines the x-axis orientation, while the third defines the orientation of the working plane.Again, we will define the working plane by aligning it to 3 Keypoints. Therefore, in order to create the back of the Spindle Base, we need to create a new working plane where the X-Y plane is parallel to the back. You may have observed that geometry can only be created in the X-Y plane.